Can any one help me ?
I have changed my heater control (HVAC) for the one with the heated seat buttons but noticed my original (HVAC) only had three connectors to it and the heated seat one has four, and i cannot see any more connectors from the loom to connect into the forth on the (HVAC) and when i operate the heated seat switches they light up two lights press again then one light. So does it have to have this forth plug to make the seats heat up ? And if so where would it connect and where could i get it if that is what is needed?
I have checked under the drivers seat and can see the wires going to the seat pads i separated the main plug by undoing the 8mm screw and checked the plugs inside i will add pictures of the plug under seat and the front of the replacement (HVAC).
Any help would be very much appreciated.
Club Feedback and general chat
1 post • Page 1 of 1